owners manual Seat Alhambra

all ratings: 0 average rating: 5

Emergencies Starting s WARNING ● Position the leads in such a way that they cannot come into contact with any moving 7. Start the engine of the vehicle with the ● Please note the safety warnings referring to ation parts in the engine compartment. boosting battery and let it run at idling ific working in the engine compartment speed. ● Do not lean on the batteries. This could re- ››› page 214. pec s sult in chemical burns. ● al The batt ery providing assistance must have 8. Start the engine of the vehicle with the flat the same voltage as the flat battery (12V) and battery and wait 2 or 3 minutes until the hnic approximately the same capacity (see imprint ec Note engine is “running”. T on battery). Failure to comply could result in The vehicles must not touch each other, oth- an explosion. Removing the jump leads erwise electricity could flow as soon as the ● Never use jump leads when one of the bat- positive terminals are connected. 9. Before you remove the jump leads, switch teries is frozen. Danger of explosion! Even af- e off the dipped beam headlights (if they ic ter the battery has thawed, battery acid could are switched on). leak and cause chemical burns. If a battery Adv freezes, it should be replaced. 10.Turn on the heater blower and heated rear Towing and tow starting ● Keep sparks, flames and lighted cigarettes window in the vehicle with the flat battery. away from batteries, danger of explosion. This helps minimise voltage peaks which Introduction Failure to comply could result in an explo- are generated when the leads are discon- sion. nected. When towing, always respect legal require- ● Observe the instructions provided by the ments. 11.When the engine is running, disconnect manufacturer of the jump leads. ation the leads in reverse order to the details For technical reasons, it is not possible to ● Do not connect the negative cable from the given above. tow a vehicle if the battery is flat. Oper other vehicle directly to the negative terminal of the flat battery. The gas emitted from theIf the vehicle comes with the Keyless Access Connect the battery clamps so they have battery could be ignited by sparks. Danger of system, towing is only allowed with the igni- good metal-to-metal contact with the battery explosion. tion on! terminals. ● Do not attach the negative cable from the The vehicle battery drains if the vehicle is If the engine fails to start, switch off the start- other vehicle to parts of the fuel system or to towed with the engine switched off and the er after about 10 seconds and try again after the brake line. ety ignition connected. Depending on the battery about 1 minute. ● The non-insulated parts of the battery Saf charge status, the drop in voltage may be so clamps must not be allowed to touch. The large, even after just a few minutes, that no jump lead attached to the positive battery electrical device in the vehicle may work e.g. terminal must not touch metal parts of the ve- the hazard warning lights. In vehicles with» hicle, this can cause a short circuit. 255

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders