Alfa Romeo 33 owners manual page 204

text version of content this owner's manual page from owners manual to the vehicle Alfa Romeo 33, year of production 1983 - 1995:

FRONT AND REAR BRAKES 4. Lubricateend of accelerator CHECKS AND INSPECTION cable before connecting it to pedal. 1. Verify condition of pedals, of pedal assembly and gasket. Then, after securing the sheath clamp plate to pedal assembly, adjust its 2. Check againstpresence of ex travel (see: Group 04- Accelerator cessive wear and mesh in bushes, pin and spacer. Control Adjustment). 5. Tighten to the prescribed torque 3. Check against presence of yield in return springs. the unions of brake master cylinder pipes and the union of clutch master 4. If necessary, remove and replace the stop light switch. cylinder pipe. 0: Tightening torques REASSEMBLY Unions of brake master cylin- der pipes 8+10 N-m For pedal assembly, reassembly, (0.8+ 1 kgam reverse the order of disassembly and 5.78 + 7.23ft.lb) apply a coat of the prescribed grease (AGIP Fl Grease 15) to the Union of clutch master cylin- 1 Electric 5 Clutch master parts subject to sliding and to return connection cylinder fork springs. der pipe 2 Cable 6 Brake master 15 + 19 N-m 3 Nut cylinder fork (1.5+ 1.9 kg-m 4 Bolt 10.85 + 13.74ft-lb) INSTALLATION 6. Fill the brake and clutch oil tank 1. Reinstall pedal assembly to body up to maximum level. by reversing order of removal and 7. Carry out bleeding of brake DISASSEMBLY complying with the following. hydraulic system (see: Brake System (1) Replace, if required, the gasket Disassemble pedal assembly operat- Bleeding) and of clutch (see: Group between pedal assemblyand body. ing as follows: 12 Hydraulic Control Sub-assembly (2) Tighten, to the prescribed 1. Remove retainer@ of pedals Hydraulic System Bleeding). torque, the nutssecuging peda l pin @ and washer@ . assembly to body. 2. Withdraw Pin and recover ped- als @ and0, and spacer‘@. 0: Tightening torque of pedal 3. Remove plastic bushes@ from assembly nuts pedals. 9+15 N-m (0.9 5 1.5kg- m 6.51 + 10.85ft.lb) (3) Lubricateforks connecting both brake and clutch pedals to the relevant master cylinders, withAGIP Fl GREASE 15; thenriconnect them. 2. Reconnect to pedal assembly the servobrake together withbrake mas- ter cylinder and then clutch master cylinder. 3. If previously removed, reconnect accelerator pedal after lubricating spacer. Make sure that accelerator pedal can freely rotate after tight- ening securing nut to the prescribed torque. 1 Retainer 5 Pedal 0: Tightening torque 2 Washer 6 Spacer St10 N-m 3 Pin 7 Pedal (0.8 f 1 kg-m 4 Bush 5.78 + 7.23ft-lb ) 22-5 May 1983

owners manual Alfa Romeo 33

owners manual Alfa Romeo 33 - year of production: 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995 - Alfa Romeo 33 owners manual EN