owners manual Ford Mustang

all ratings: 0 average rating: 5

Maintenance You have limited engine power when in the At this time, you may notice your engine fail-safe mode, so drive your vehicle with coolant temperature gauge needle move caution. Your vehicle will not maintain toward the H and the POWER REDUCED high-speed operation and the engine will TO LOWER TEMP message may appear operate poorly. in the information display. Remember that the engine is capable of You may notice a reduction in vehicle automatically shutting down to prevent speed caused by reduced engine power. engine damage. In this situation: In order to manage the engine fluid 1. Pull off the road as soon as safely temperatures, your vehicle may enter this possible and switch off the engine. mode if certain high-temperature and 2. Tow your vehicle to an authorized high-load conditions take place. The dealer. amount of speed reduction depends on many factors such as vehicle loading, 3. If this is not possible, wait a short towing, grade and ambient temperature. period for the engine to cool. If this occurs, there is no need to pull off 4. Check the coolant level and add if low. the road. You can continue to drive your 5. Re-start the engine and drive your vehicle while this message is active. vehicle to an authorized dealer. The air conditioning may also cycle on and Note:Driving your vehicle without repair off during severe operating conditions to increases the chance of engine damage. protect overheating of the engine. When Contact an authorized dealer as soon as the engine coolant temperature decreases possible. to a normal operating temperature, the air conditioning will turn on once again. Engine Fluid Temperature If the engine coolant temperature gauge Management (If Equipped) moves fully into the red (hot) area, or if the coolant temperature warning or service WARNINGS engine soon messages appear in your To reduce the risk of crash and injury, information display: be prepared that the vehicle speed 1. Pull off the road as soon as safely may reduce and the vehicle may not possible and shift the transmission into be able to accelerate with full power until P. the fluid temperatures reduce. 2. Leave the engine running until the Never remove the coolant reservoir coolant temperature gauge needle cap while the engine is running or hot. moves away from the red (hot) area. After several minutes, if the Your vehicle can pull a trailer, but because temperature does not drop, follow the of the added load, your vehicle’s engine remaining steps. may temporarily reach higher 3. Switch the engine off and wait for it to temperatures during severe operating cool before checking the coolant level. conditions such as ascending a long or 4. If the coolant level is normal, restart steep grade while pulling a trailer in high your engine and continue. temperatures. 218 Mustang (), enUSA, First Printing

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders