Alfa Romeo 33 owners manual page 187

text version of content this owner's manual page from owners manual to the vehicle Alfa Romeo 33, year of production 1983 - 1995:

DIFFERENTIAL AND DRIVE SHAFT ASSEMBLY way along the splines; to this effect 6. Fit washers on shaft, wheel side, 7. Fit lock ring following disas- splines should be covered with tape.sembly procedure according to numbering marked at in reverse se- 2. Following disassembly proce-quence. time of disassembly. Now fit the dure in reverse sequence, now fit the8.Fit the boot; fit new clampsand constant-speed joint with the help of inner race and the cage. tighten them using suitable pliers a press, of two half-plates and of tool 3. Fit steel balls as shown in the A.3.0605. being careful not to damage the boot figure and verify that the joint works in doing so. properly. 9. Fit the three plates to the inner cover,insert relevant screws and washers, and lastly fit the outer cover onto the six screws. INSTALLATION 1. Insert shaft into wheel hub. 2. Connect shaft to differential drive shaft and lock securing screws to specified torque. @ : Tightening torque 33 -F 36 N-m 7. Finish up lubricating by packing (3.4 + 3.7 kg-m joint with 40 g (1.4102) more of the 24.56 f 26.75 ft-lb) CAUTION: above mentioned grease and make Do not exchange this joint’s steel sure that balls are completely sur- rounded by grease. balls with those of the outer joint as their diameter is different. 8. Fit boot on joint; fit new clamps and tighten them using suitable pliers being careful not to damage the boot in doing so. 4. Fit inner cover to the joint and then fit the latter on the shaft with the help of a press, of twohalf- plates, of a base and a punch.3. By means of anew nut, secure wheel hub to shaft. Tighten nut to caulk it. specified torque, then 0: Tightening torque 226 + 275 Ndrn (23+ 28 kg-m 166.30 + 202.46 ft.lb) INNER JOINT (B) Thoroughly coat with grease(Moly- kote 2461 C or Optimal Olistamoly 2 5. Pack joint with 40 g (1.4102) I- N 584) the cage, the inner race and more of the above mentioned grease the steel balls; pack the joint’s recess and make sure that balls are with 40 g (1.4102) of the same type grease. completely surroundedby grease. 6. Fit both seal rings on the joint’s 1. Fit boot on shaft being extreme- outer ring. ly careful not to damage it in any 17-S May 1983

owners manual Alfa Romeo 33

owners manual Alfa Romeo 33 - year of production: 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995 - Alfa Romeo 33 owners manual EN