owners manual Subaru Outback

owners manual Subaru Outback - year of production: 2009, 2010, 2011, 2012, 2013, 2014 - Subaru Outback Legacy IV 4 owners manual EN

Document: pdf (18.3 MB) 474 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Subaru Outback, year of production 2009 - 2014:

2-10 Keysanddoors NOTE &Selecting audible signal op-&Replacing the battery If the interval between presses is tooeration short when you press the “ ” buttonUsing an electronic chirp, the system willCAUTION three times, the system may not re-give you an audible signal when the doors spond to the signals from the remotelock and unlock. If desired, you may turn. Donotletdust,oilorwatergeton transmitter. the audible signal off. or in the transmitter when repla- To deactivate the audible signal, performcing the battery. &Sounding a panic alarm the following procedure. You can also use. Be careful not to damage the the same steps to restore the function.printed circuit board in the trans- 1. Sit in the driver’s seat and shut allmitter whenreplacing the battery. doors and the rear gate Becarefulnottoallowchildrento 2. Press the unlock side of the powertouch the battery and any re- door locking switch. moved parts; children could 3. Insert the key into the ignition switch.swallow them. 4. While holding down the unlock side of. There is a danger of explosion if the power door locking switch, pull the keyan incorrect replacement battery out and re-insert it into the ignition switchis used. Replace only with the at least 5 times within 10 seconds aftersame or equivalent type of bat- performing step 2. tery. 5. Open and close the driver’s door. Batteries should not be exposed within 10 seconds after performing step 4.to excessive heat such as sun- To activate the alarm, press the “PANIC”6. To indicate completion of the setting,shine, fire or the like. button once. the turn signal lights flash 3 times and the The horn will sound and the turn signalchirp sounds 3 times.Ifthe transmitter fails to operate when lights will flash. used within the standard distance, this To deactivate the panic alarm, press anyYou may have the above procedure may indicate a weak battery. Replace the button on the remote transmitter. If aperformed by your SUBARU dealer.battery as soon as possible. The battery button on the remote transmitter is not can be replaced by your authorized pressed, the alarm will be deactivated SUBARUdealer.Ifyoureplacethebattery after approximately 30 seconds. by yourself, use utmost care that no dust, oil or water enters the transmitter.

Download PDF

Click here to download a pdf file with an instruction manual for Subaru Outback
year of production from: 2009

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.