owners manual Mercedes S

all ratings: 0 average rating: 5

Changingawheel 409 R Raising the vehicle makesurethatthedistance between the underside of the tires and the ground does GWARNING not exceed 1.2 in (3 cm). If you do not position the jack correctly at the R never place your hands and feet under the appropriate jacking point of the vehicle, the raised vehicle. jack could tip over with the vehicle raised. R donotlie under the vehicle. There is a risk of injury. R donotstart the engine when the vehicle is Only position the jack at the appropriate raised. jacking point of the vehicle. The base of the R donotopenorcloseadoororthetrunklid jack must be positioned vertically, directly whenthevehicle is raised. under the jacking point of the vehicle. R makesurethatnopersonsarepresentin !Thejackisdesignedexclusively forthe vehicle when the vehicle is raised. jackingupthevehicleatthejackingpoints. Vehicleswithhubcaps:thehubcapcovers Otherwise,yourvehiclecouldbedamaged. the wheel bolts. Before you can unscrew the wheel bolts, you must remove the hub caps. Observethefollowingwhenraisingthe Twodifferent variants can be installed. vehicle: R to raise the vehicle, only use the vehicle- specific jack that has been tested and approved by Mercedes-Benz. If used incorrectly, the jack could tip over with the tires vehicle raised. R the jack is designed only to raise and hold and the vehicle for a short time while a wheel s is being changed. It is not suited for el performing maintenance work under the vehicle. Whe R avoid changing the wheel on uphill and Vehicles with plastic hub caps: downhill slopes. XToremove:turnthecentercoverofhub R before raising the vehicle, secure it from cap :counter-clockwise and remove. rolling away by applying the parking brake XToinstall: before installing, ensure that and positioning wheel chocks. Do not hubcap:isintheopenposition.Todo disengage the parking brake while the so, turn the center cover counter- vehicle is raised. clockwise. R the jack must be placed on a firm, flat and XPlacehubcap:inpositionandturnthe non-slip surface. On a loose surface, a large, flat load-bearing underlay must becenter cover clockwise until you feel and used. On a slippery surface, a non-sliphear hub cap : engage. underlay must be used, e.g. rubber mats. XMakesurethathubcap:isinstalled R donotusewoodenblocksorsimilar securely. objects as a jack underlay. Otherwise, the jack will not be able to achieve its load- bearing capacity due to the restricted height. Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders