owners manual Jeep Commander

owners manual Jeep Commander - year of production: 2006, 2007, 2008, 2009, 2010 - Jeep Commander owners manual XK XH EN

Document: pdf (7.46 MB) 460 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Jeep Commander, year of production 2006 - 2010:

MAINTAINING YOUR VEHICLE 385 Fluid Level Check (5.7L Engine) 6. Removethedipstick again, and note the fluid level on Check the fluid level while the transmission is at normalboth sides. The fluid level should be between the “HOT” operating temperature. This occurs after at least 15 miles(upper) reference holes on the dipstick at normal operat- (25 km) of driving. At normal operating temperature theing temperature. The fluid level is only valid if there is a fluid cannot be held comfortably between the fingertips.solid coating of oil on both sides of the dipstick. If the Tocheckthefluidlevelproperly,thefollowingprocedurefluid is low, add as required into the dipstick tube. Do must be used: not overfill. After adding any quantity of oil through the oil fill tube, wait a minimum of two minutes for the oil to 1. Operatetheengineatidlespeedandnormaloperating fully drain into the transmission before rechecking the temperature. fluid level. 2. The vehicle must be on level ground.NOTE: Ifitisnecessarytocheckthetransmissionbelow 3. Fully apply the parking brake, and press the brakethe operating temperature, the fluid level should be pedal. between the two “COLD” (lower) holes on the dipstick 7 with the fluid at approximately 70°F (21°C) (room tem- 4. Place the shift lever momentarily in each gear positionperature). If the fluid level is correctly established at ending with the shift lever in PARK.room temperature, it should be between the “HOT” 5. Removethedipstick, wipe it clean and reinsert it until(upper) reference holes when the transmission reaches seated. 180°F (82°C). Remember it is best to check the level at the normal operating temperature.

Download PDF

Click here to download a pdf file with an instruction manual for Jeep Commander
year of production from: 2006

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.