Audi A4 B8 owners manual page 30

text version of content this owner's manual page from owners manual to the vehicle Audi A4, year of production 2008 - 2015:

document_0900452a81b1b9de.book Seite 28 Donnerstag, 26. Juli 2007 9:16 09 28 Driver information system • Driving time and can be switched back on at any time so that they again appear • Distance covered in the display. You can also cancel all the values in the single journey memory or the total journey memory at the same time ⇒ page 28. Speed warning function Note Applies to vehicles: with speed warning function The information in the memory is cancelled if the battery is Introduction disconnected. The speed warning function can help you keep below a pre-set maximum speed. Applies to vehicles: with on-board computer Basic settings for the on-board computer The speed warning function will warn you if the vehicle exceeds the pre-set maximum speed. The system gives an audible warning The basic settings for the on-board computer can be signal if the set speed is exceeded by about 3 km/h. A warning adjusted via the sound system or MMI*. symbol will also appear in the display . On some models the symbol may look slightly different. The speed warning function has two different warning speeds, which operate independently and serve slightly different purposes: Speed limit warning 1  With speed limit warning 1, the maximum speed can be changed while driving. The speed limit that has been set remains stored until the ignition is switched off, or until it is changed or cleared. Fig. 21 MMI display: The speed limit warning symbol  for speed limit warning 1 will On-board computer appear in the display if you exceed the pre-set speed. It goes out again if the speed is reduced below the set speed limit. – Select: Function selector button CAR > Instrument The symbol also goes out if the speed is increased to more than cluster > On-board computer 1 or On-board computer 2. about 40 km/h above the set speed for at least 10 seconds. This cancels the speed limit that was originally set. You can zero all the values in the single journey memory or the total Setting speed limit warning 1 ⇒ page 29. journey memory at the same time by selecting the Reset menu item. You can also define which items of information you wish to have Speed limit warning 2  displayed by the on-board computer. If one of these items is You are recommended to store this speed limit warning if you switched off, it will not appear in the display. However, the corre-always wish to be reminded of a particular speed limit. This could sponding figures will still be registered by the on-board computer be when driving in countries with general speed limits, or if you

owners manual Audi A4

owners manual Audi A4 - year of production: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Audi A4 B8 owners manual EN