Toyota 4Runner 4 IV N210 owners manual page 252

text version of content this owner's manual page from owners manual to the vehicle Toyota 4Runner, year of production 2003 - 2009:

’04 4Runner_U (L/O 0308) 3. Simultaneously press and hold theProgramming a rolling code system The ceiling ountm ed garage door opener hand-held garage transmitter button motor should now recognize the If your device is “Rolling Code” along with the selected HomeLink unit and be able activate the but- equipped, it is necessary to follow HomeLink ton. steps 1 through 4 under the heading garage door up/down. 4. When the indicator light on the “Programming the HomeLink” before 4. Repeat steps 1 through 3 for each re- proceeding with the steps listed below. HomeLink changes from a slow to a maining HomeLink button to program rapid flash after 20 seconds, you can 1. Locate the “training” button on the ceil-another rolling code system. release both buttons. ing mounted garage door opener motor.Programming an entrance gate/program- ming all devices in the Canadian market 5. Test the operation of the HomeLink byThe exact location and color of the pressing the newly programmed button.button may vary by brand of garage If programming a garage door opener, door opener. Refer to the owner’s 1. Decide which of the 3 HomeLink but- check to see if the garage door opensguide supplied by the garage door tons you want to program. and closes. opener manufacturer for the location of 2. Place your hand-held gate/device If the garage door does not operate, iden-this “training” button. transmitter 25 to 75 mm (1 to 3 in.) away from the surface of the 2. Press the “training” button on the ceil- tify if your garage transmitter is of the HomeLink . “Rolling Code” type. Press and hold the ing mounted garage door opener motor. Keep the indicator light on the HomeLink programmed HomeLink button. The ga- Following this step, you have 30 secondsin view while programming. rage door has the rolling code feature ifin which to initiate step 3 below. 3. Press and hold the selected the indicator light (on the HomeLink) 3. Press and release the vehicle’s pro- flashes rapidly and then remains lit after HomeLink button. 2 seconds. If your garage transmitter isgrammed HomeLink button twice. The 4. Continuously press and release (cycle) the “Rolling ode”C type, proceed to thegarage door may open. If the door the hand-held gate/device transmitter heading “Programming a rllino g code sys-does open, the programming process isbutton every two seconds until step 5 tem”. complete. If the door does not open, is complete. 6. Repeat steps 2 through 5 for each re-press and release the button a third time. This third press and release will 5. When the indicator light on the maining HomeLink button to program another device. complete the programming process by HomeLink changes from a slow to a opening the garage door. rapid flash after 20 seconds, you can release both buttons. 252 2004 4RUNNER from Aug. ’03 Prod. (OM35811U)

owners manual Toyota 4Runner

owners manual Toyota 4Runner - year of production: 2003, 2004, 2005, 2006, 2007, 2008, 2009 - Toyota 4Runner 4 IV N210 owners manual EN