or
owners manual Saab 9-5
owners manual Saab 9-5 - year of production: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005 - Saab 9 5 I 1 YS3E owners manual EN
Document: pdf (15.34 MB) 272 pages
all ratings: 0 average rating: 5
text version of content this owner's manual page from owners manual to the vehicle Saab 9-5, year of production 1997 - 2005:
228 Car care and technical information
2 Wind the jack up to a suitable height 7 Check-tighten the wheel bolts after a
before placing it under the recess in the few miles.
sill. Tightening torque
Make sure that the jack fully engages Light-alloy wheels: 80 ft.lbs. (110 Nm)
the recess in the sill and that the base of Steel wheels: 80 ft.lbs. (110 Nm)
the jack is steady and flat on the ground.
3 Remove the wheel cover (where appli-
cable).
Loosen the wheel bolts by half a turn.
4 Wind the jack to raise the wheel clear of
the ground. Remove the wheel bolts and
130 lift off the wheel.
IB1 5 Fit the wheel and screw in the bolts in the
Jacking points for a trolley jack sequence shown (opposite pairs).
Tighten the bolts enough for the bolts
and wheel to be seated correctly.
If a floor jack is used, it can be applied to the 6 Lower the car and tighten the wheel
standard jacking points used by the dealer.bolts to the correct torque in the
A floor jack can lift both front wheels or both sequence shown (opposite pairs).
rear wheels off the ground simultaneously. Tightening torque
A jack stand must then be applied under-Light-alloy wheels: 80 ft.lbs. (110 Nm)
neath the front of the engine subframe (at Steel wheels: 80 ft.lbs. (110 Nm)
the fixing point for the towrope-attachment Do not overtighten the bolts using a per-
eye) or to the rear towrope-attachment eye cussion nut tightener: not only can this
(or under the trailer hitch, if fitted).damage the wheels but it can also make
it impossible to undo the bolts using the
NOTE wheel wrench in the car’s toolkit.
Apply the jack only to the jacking points NOTE
indicated. When refitting wheel covers (where
1 Put the car in 1st gear (automatic trans-applicable), make sure that the valve
mission: move selector to the P position) protrudes through the hole in the wheel
and apply the parking brake. cover.
Download PDFClick here to download a pdf file with an instruction manual for Saab 9-5
year of production from: 1997
Do you prefer pdf format?Find out how to download
Enter the code to download PDF file:
:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Saab 9 5 I 1 YS3E owners manual
pages 225 - 231
pages 225 - 231
Saab 9 5 I 1 YS3E owners manual
page 228 / 272
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDFOther available language versions of this manual:
- Saab 9 5 I 1 YS3E instrukcja PLshow the owner's manual
pdf - 23.01 MB
Others owner's manuals for this model:
Saab 9-5 2005 - 2009 EN - Saab 9-5 FL I 1 owners manual - pdf - 22.3 MB
Saab 9-5 1997 - 2005 PL - Saab 9-5 I 1 YS3E instrukcja - pdf - 23.01 MB
Saab 9-5 2005 - 2009 EN - Saab 9-5 FL I 1 owners manual - pdf - 22.3 MB
Saab 9-5 1997 - 2005 PL - Saab 9-5 I 1 YS3E instrukcja - pdf - 23.01 MB