owners manual Peugeot 406

all ratings: 0 average rating: 5

115 YOUR 406 IN DETAIL AUTOMATIC SWITCHING ON Operating check If the brightness sensor does not OF THE LIGHTS function correctly, the system acti- Side lights and dipped beam head- vates the function (the lights come on). Activation The driver is alerted by the flashing of lamps switch on automatically if the the ''dipped beam'' warning light on the light is poor, or during continuous Activation of this function is accom- operation of the windscreen wipers. instrument panel. panied by an audible signal and the They switch off as soon as the light Contact a PEUGEOTdealer to have message "Automatic lighting of becomes bright enough or the wind- the system checked. the headlamps activated"on the screen wipers stop. multifunction display. This function is active when the vehicleNote: Always operate the lighting is supplied to the customer. Follow me Home controls manually where this is pos- To disarm or activate the function:sible. When there is a low level of bright- ☞ Place the key in the accessories ness or at night, if you leave your position (1st notch), vehicle, the side lights and the Disarming dipped beam lights may remain on ☞ Press the end of the lights stalk for approximately one minute. for more than two seconds. Disarming of the function is accom- To do this: panied by an audible signal and the message "Automatic lighting of Note: In foggy weather, the bright- ☞place the lights stalk in the AUTO the headlamps deactivated" on theposition, ness sensor can detect sufficient multifunction display. light. Because of this, the lights do ☞place the key in the accessories not come on automatically. position (first notch), When driving, if this function is switched off when the headlamps Do not cover the brightness sen- ☞press the end of the lights stalk for would switch on in automatic mode, sor connected to the rain sensor, more than two seconds, the lights remain on. It is however located in the windscreen behind ☞place the lights stalk in the 0 posi- possible to disarm this function and the mirror. It is used for automaticswitch off the lights by:tion, switching on of the lights. ☞flash the headlamps, –manually switching off the lights using the lights stalk, ☞get out of the car and lock it. –switching off the engine. 26-05-2003

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders