Chevrolet Silverado I 1 owners manuals page 155

text version of content this owner's manual page from owners manual to the vehicle Chevrolet Silverado, year of production 1998 - 2006:

Keep the original transmitter for use in other vehicles as 2. Position the end of your hand-held transmitter ® well as for future HomeLink programming. It is also about 1 to 3 inches (3 to 8 cm) away from the ® recommended that upon the sale of the vehicle, HomeLink buttons while keeping the indicator the programmed HomeLink® buttons should be erased light in view. ® for security purposes. Refer to “Erasing HomeLink 3. Simultaneously press and hold both the desired ® Buttons” or, for assistance, contact HomeLink on button on HomeLink® and the hand-held transmitter the Internet at: www.homelink.com or by calling button. Do not release the buttons until Step 4 1-800-355-3515. has been completed. Be sure that people and objects are clear of the garage Some entry gates and garage door openers may door or gate operator you are programming. When require you to substitute Step 3 with the procedure programming a garage door, it is advised to park outside noted in “Gate Operator and Canadian of the garage. Programming” later in this section. It is recommended that a new battery be installed in 4. The indicator light will ﬂash slowly at ﬁrst and then your hand-held transmitter for quicker and more ® accurate transmission of the radio frequency. rapidly after HomeLink successfully receives the frequency signal from the hand-held transmitter. Programming HomeLink® Release both buttons. 5. Press and hold the newly-trained HomeLink® button Your vehicle’s engine should be turned off while and observe the indicator light. programming the transmitter. Follow these steps to If the indicator light stays on constantly, program up to three channels: programming is complete and your device should 1. Press and hold down the two outside buttons, activate when the HomeLink® button is pressed releasing only when the indicator light begins to and released. ﬂash, after 20 seconds. Do not hold down the ® To program the remaining two HomeLink buttons, buttons for longer than 30 seconds and do not begin with Step 2 under “Programming HomeLink®.” repeat this step to program a second and/or third Do not repeat Step 1 as this will erase all of the ® transmitter to the remaining two HomeLink buttons. programmed channels. 2-69

owners manual Chevrolet Silverado

owners manual Chevrolet Silverado - year of production: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006 - Chevrolet Silverado I 1 owners manuals EN